PLEASE PROVIDE A COPY OF THIS SHEET TO THE SERVICING TECHNICIAN.
PRIOR TO ORDERING THIS PART, THE FOLLOWING MUST BE VERIFIED:


Tech Tip Part Description:   MAINTENANCE REMINDER

Tech Tip Description:   Due to lack of proper maintenance, failures of the double cardan universal joints (u-joints) have occurred on some heavy-duty Ram front drive shafts.

The joint must be lubricated with a Needle Nose Grease Gun Adapter during scheduled maintenance every 8000 miles (gas)/7500 miles (diesel).

The needle point greasing adapter tool is included in the MOPAR Express Lane tool kit and also readily available through other tool providers. Recommended Needle Nose Grease Gun Adapters: Matco MCOGGA3A / GGA3A, Snap-on YA761 or YA801 or Lincoln G901 or 5803 (Tip)

The double cardan joint is equipped with a low profile needle point grease fitting that may require cleaning to insure proper greasing.

Lubricate the double cardan joint per the maintenance schedule using Mopar type MS-6560 lithium based grease or an equivalent. Lubrication requirements are detailed in service information and the owners manual. There is also an under hood reminder sticker on the left front fender.

Inspect the double cardan joint near the transfer case front output shaft during service. Check for signs of distress include gaps in the bearing area and rusty powder on the yoke surfaces and repair as necessary.

Proper maintenance at the required interval will greatly reduce the potential for premature double cardan joint failure.


CHRYSLER RESERVES THE RIGHT TO BACK CHARGE DEALERS THAT DO NOT COMPLY WITH CHRYSLER WARRANTY AND POLICY PROCEDURES AS OUTLINED IN THE DEALER P&P MANUAL


 

StarParts® is a registered trademark of Chrysler.

© 2022 Chrysler Group LLC, All rights reserved.