PLEASE PROVIDE A COPY OF THIS SHEET TO THE SERVICING TECHNICIAN.
PRIOR TO ORDERING THIS PART, THE FOLLOWING MUST BE VERIFIED:


Tech Tip Part Description:   Blower Motor

Tech Tip Description:   Before replacing the blower motor, check for 12 volts at the resistor power supply.

A. If no voltage is present, there is a problem with the blower switch circuit, do not replace the blower motor or resistor.

If the above check is good, check for voltage at the blower motor power supply wire from the resistor to the blower motor. Cycle the blower switch, voltage will vary depending on what speed is selected.

A. If no voltage is present at the blower motor supply lead, replace the blower motor resistor. (IMPORTANT: Once the new resistor is in place, turn the blower switch to high before supplying power to the circuit. Run the blower motor on high for at least two minutes before checking the lower speeds.)

B. If voltage is present but the blower motor doesnt operate, replace the blower motor.

______________________________________

Contact Us at CAGRIS@Chrysler.com for feedback related ONLY to this GPOP Tech Tip. DO NOT email regarding repair procedures unrelated to this Tech Tip or part order inquires. Please include the Part Number (s) and Tech Tip Part Description of the Tech Tip you are referencing for our tracking system.


CHRYSLER RESERVES THE RIGHT TO BACK CHARGE DEALERS THAT DO NOT COMPLY WITH CHRYSLER WARRANTY AND POLICY PROCEDURES AS OUTLINED IN THE DEALER P&P MANUAL


 

StarParts® is a registered trademark of Chrysler.

© 2022 Chrysler Group LLC, All rights reserved.